Home / News
  • Why do injection molds need to be tried in advance?

    If there is a problem with injection molded parts, it may be caused by the plasticization of the mold or the injection molding stage, and sometimes it is also related to the unreasonable design. In addition, the position size, the number of mold cavi...

    read more
  • Reasons for plastic mold material failure

           General mold making includes mold design, material selection, heat treatment, machining, commissioning and installation processes. According to the survey, the material used and the heat treatment are the main factors affecting the service lif...

    read more
  • Structural elements and accessory requirements to be considered in plastic mold design

    The design and manufacture of plastic molds will be closely related to the process of plastic processing. The success or failure of plastic processing depends largely on the effect of mold design and the quality of mold manufacturing, and the design ...

    read more
  • Explanation of terms in the mold industry

    Upper pole: the upper end point of the up and down movement of the press slider. Lower pole: the lower end point of the up and down movement of the press slider. Burrs: sharp protrusions on the edge of the punched section after punching. Burr surface...

    read more
  • What are the factors that affect injection molding?

    The plastic injection molding manufacturing process is relatively simple, but there are many details that need to be paid attention to. If ignored, it may lead to deformation of the injection molded product. So in practice, what factors affect plasti...

    read more
  • Factors affecting the life of automobile molds

    Factors affecting the life of automobile molds The rapid development of the modern automobile industry has made people's requirements for all aspects of automobiles become higher and higher. At the same time, the service life of automobile molds has ...

    read more
Contact Us